Odyssey® F Imager Specifications
Detection Channel Summary
Model | Channel | Excitation | Emission |
---|---|---|---|
9150, 9180 | 800 | 785 nm | 813 – 832 nm |
9150, 9180 | 700 | 685 nm | 710 – 730 nm |
9150, 9180 | 700A | 685 nm | 813 – 832 nm |
9180 | 520 | 520 nm | 570 – 610 nm |
9180 | 520A | 520 nm | 710 – 730 nm |
9180 | 520B | 520 nm | 813 – 832 nm |
9180 | 488 | 488 nm | 538 – 552 nm |
9180 | 488A | 488 nm | 570 – 610 nm |
9180 | 488B | 488 nm | 710 – 730 nm |
9180 | 488C | 488 nm | 813 – 832 nm |
Specifications
Unless otherwise specified, the following apply to both Odyssey F 9150 and Odyssey F 9180.
Imaging System
Dynamic Range: >6 logs
Pixel Resolution: 21 μm, 42 μm, 84 μm, 169 μm, 337 μm
Focusing Range: -1.00 – 5.00 mm
Solid-state diode lasers:
Model 9150: 685, 785
Model 9180: 488, 520, 685, and 785
Detection Modes: Fluorescence
Laser lifetime: 40,000 hours of operation
Microplate Insert: Accessory alignment guide for 4 microplates
Microscope Slide Holder: Accessory holder for 12 slides
Image Scan Times
Western blot: 4 minutes for a 10 cm x 10 cm membrane scanned at 169 μm using 2 lasers at a time.
Microplate: 3 minutes for a single, 96-well microplate scanned at 169 μm using 2 lasers at a time.
Dimensions: 37 H × 53 W × 62 D cm (15 H × 21 W × 24.5 D inches) With the hood fully open, the Odyssey F requires 74 cm of vertical clearance.
Image field size: 25 cm W × 18 cm D (9.8” W × 7.1” D)
Weight: 32 kg (70 lbs)
Laser Source
The Odyssey F Imager is a class 1 laser product.
All lasers run at a 50% duty cycle between 20KHz and 50KHz and diverge at 6 degrees.
Laser Source | Maximum Internal Laser Power |
488 nm | 12mW |
520 nm | 20mW |
685 nm | 20mW |
785 nm | 50mW |
Operating Specifications
Operating Conditions: For indoor use only; operating temperature and dew point not greater than 22 °C, non-condensing; altitude not to exceed 2000 m.
Environmental Conditions: Pollution Degree 2.
Power Requirements: Universal input range is between 100-240 VAC (voltage fluctuations not to exceed 10% of the nominal voltage); 2.2 Amp maximum; at 120V, 0.5 Amp typical when idle; 50/60 Hz.
Network Protocol: TCP/IP.
Network Connection: Cat. 5e RJ45, 10BASE-T/100BASE-TX/1000BASE-T. Use only the supplied cable.